spec no: dsab2841 rev no: v.4 date: nov/08/2005 page: 1 of 5 approved: j. lu checked: joe lee drawn: y.l.li erp:1351000009 notes: 1. all dimensions are in millimeters (inches), tolerance is 0 .25(0.01")unless otherwise noted. 2. specifications are subject to change without notice . package dimension s & & & & internal circuit diagram description the hyper red source color devices are made with dh ingaalp on gaas substrate light emitting diode. p / n : apsa02 - 41surkwa hyper red features 0.2inch digit height. low current operation. excellent character appearance. i.c. compatible mechanically rugged. gray face,white segment. package :650pcs / reel. rohs compliant. surface mount display
spec no: dsab2841 rev no: v.4 date: nov/08/2005 page: 2 of 5 approved: j. lu checked: joe lee drawn: y.l.li erp:1351000009 selection guid e part no. dice lens type iv (ucd) @ 10ma min. typ. apsa02 - 41surkwa hyper red (ingaalp) white diffused 8000 30400 common anode, rt. hand decimal. description electrical / optical characteristics at t a =25 c absolute maximum ratings at t a =25 c note: 1. 1/10 duty cycle, 0.1ms pulse width. parameter hyper red units power dissipation 170 mw dc forward current 30 ma peak forward current [1] 185 ma reverse voltage 5 v operating/storage temperature - 40c to +85c symbol parameter device typ. max. test conditions units peak peak wavelength hyper red 650 nm i f =20ma d dominant wavelength hyper red 635 nm i f =20ma ? 1/2 spectral line half - width hyper red 28 nm i f =20ma c capacitance hyper red 35 pf v f =0v;f=1mhz v f forward voltage hyper red 1.95 2.5 v i f =20ma i r reverse current hyper red 10 ua v r = 5v
spec no: dsab2841 rev no: v.4 date: nov/08/2005 page: 3 of 5 approved: j. lu checked: joe lee drawn: y.l.li erp:1351000009 hyper red apsa02 - 41surkwa
spec no: dsab2841 rev no: v.4 date: nov/08/2005 page: 4 of 5 approved: j. lu checked: joe lee drawn: y.l.li erp:1351000009 tape specifications (units : mm ) recommended soldering pattern (units : mm ) apsa02 - 41surkwa
spec no: dsab2841 rev no: v.4 date: nov/08/2005 page: 5 of 5 approved: j. lu checked: joe lee drawn: y.l.li erp:1351000009 packing & label specifications apsa02 - 41surkwa remarks: if special sorting is required (e.g. binning based on forward voltage, luminous intensity/ luminous flux or wavelength), the typical accuracy of the sorting process is as follows: 1. wavelength: +/ - 1nm 2. luminous intensity/ luminous flux: +/ - 15% 3. forward voltage: +/ - 0.1v note: accuracy may depend on the sorting parameters.
|